Alles so wie es soll, keine Startfunktion durch das Zündschloss, mein Fehler.
Electrical Manual sagt:
Battery voltage is supplied to the BCM at all times through themain fuse.The BCM provides and monitors a voltage signal to the ignition switch.This signal changes depending on the position of the IGN switch.When the engine stop switch is in the RUN position, a CAN message is sent, signaling the BCM that the switch is in the RUN position. If CAN communication is interrupted while the engine is running, the BCM checks for the signal from the redundant engine stop switch circuit.When the start switch is pressed, a CAN message is sent tothe BCM.The BCM provides power to the starter solenoid.This energizes the solenoid and full battery power is sent to the starter.The BCM disables the starter solenoid if the startswitch is pressed for more than 10 seconds
__________________
'First shalt thou take out the Holy Pin. Then, shalt thou count to three. No more. No less. Three shalt be the number thou shalt count, and the number of the counting shall be three."